Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires

Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires

This study compares the performance of two plastering mortars. The first one was produced at a 1:6 proportion of quicklime powder and sand (by volume) and ripened. The second had the same proportion but underwent a water withdrawal process in the oven. The mortars were given the same content of ceme...

Descripció completa

Guardat en:

Dades bibliogràfiques
Autors principals:	Canova, José Aparecido, Bergamasco, Rosangela, Angelis Neto, Generoso de, Gleize, Philippe Jean Paul
Format:	Online
Idioma:	por
Publicat:	ANTAC - Associação Nacional de Tecnologia do Ambiente Construído 2012
Accés en línia:	https://seer.ufrgs.br/ambienteconstruido/article/view/20515
Etiquetes:	Afegir etiqueta Sense etiquetes, Sigues el primer a etiquetar aquest registre!

Ítems similars

Structural behavior evaluation of precast slabs prototypes made with tire rubber residue concrete
per: Trigo, Ana Paula Moreno, et al.
Publicat: (2008)

Evaluation of rheological properties of mortar with TiO2 addition
per: Dantas, Sérgio Roberto Andrade, et al.
Publicat: (2021)

Shrinkage and the development of mechanical properties in rendering mortars
per: Bastos, Pedro Kopschitz Xavier, et al.
Publicat: (2008)

Sustainability of the housing of the amazon rubber tapper
per: Lima, Valdeci Candido de
Publicat: (2010)

Propriedades nanomecânicas do silicato de cálcio hidratado de síntese
per: Pelisser, Fernando, et al.
Publicat: (2009)

Analysing the logistics impact on the cost composition of a mechanised spraying process of rendering mortar
per: Brandstetter, Maria Carolina Gomes de Oliveira, et al.
Publicat: (2018)

Correlation between modulus of elasticity dynamic and mechanical strengths of cement mortars and sand with lime addition
per: Silva, Narciso Gonçalves da, et al.
Publicat: (2008)

The effectiveness of TiO2 additions to mortar to maintain initial conditions in terms of its reflectance to solar radiation
per: Dantas, Sérgio Roberto Andrade, et al.
Publicat: (2017)

Mechanical properties: wood lumber versus plastic lumber and thermoplastic composites
per: Dias, Bernardo Zandomenico, et al.
Publicat: (2017)

Impact of the mixer and time of mixing on the properties of industrialized mortar
per: Romano, Roberto Cesar de Oliveira, et al.
Publicat: (2009)

Mechanical physical study of concrete substitutes with silica powder exposed in simulated aggressive environment
per: Giménez, Alejandro, et al.
Publicat: (2018)

Rheological characterization of cement paste: association of complementary techniques
per: Betioli, Andrea Murillo, et al.
Publicat: (2009)

Incorporação de lodo calcinado de estação de tratamento de água como material cimentício suplementar
per: Ruviaro, Artur Spat, et al.
Publicat: (2020)

Influence of cement type and water content on the fresh state properties of ready mix mortar
per: Casali, Juliana Machado, et al.
Publicat: (2018)

Influence of polypropylene microfibre (PPMF) dispersion procedure on fresh and hardened rendering mortar properties
per: Dantas, Sérgio Roberto Andrade, et al.
Publicat: (2020)

Learning, composition and placement in the architecture project.
per: Pérgolis, Juan Carlos, et al.
Publicat: (2016)

Índice de Serviço das Calçadas (ISC)
per: Silva, Otavio Henrique da, et al.
Publicat: (2018)

Use of natural additives in construction materials – a review
per: Hernández, Eddisson
Publicat: (2019)

Composite slim floor: elements and construction process
per: Kochem, Raimundo Fagner Freitas, et al.
Publicat: (2018)

Crossed perspectives around the doctorate in architecture.
per: Garric, Jean-Philippe
Publicat: (2015)

BIM and LCA integration proposal using service compositions
per: Silva, Bruno Thiago Rego Valeriano, et al.
Publicat: (2021)

Drying parameters of rendering mortars
per: Salomão, Maria Cláudia de Freitas, et al.
Publicat: (2018)

Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars
per: Silva Neto, Gilberto Alves da, et al.
Publicat: (2018)

Use of adherent additives in designing asphalt hot mixtures: a review
per: Vasquez Llamo, Reinerio Elden, et al.
Publicat: (2021)

Digital detailing on the edge: joining of complex curved composite panels
per: Chaszar, Andre
Publicat: (2013)

The Guillermo Bermúdez Umaña’s composition at the Carabelas Building (1969-1972)
per: Güiza-Chaves, Juan Pablo
Publicat: (2021)

Kaufmann desert house. The landscape through the analysis of the architectural composition
per: Rojas Quiñones, Plutarco
Publicat: (2021)

Paradoxical Effects of a Forgotten Subject: Life and Death of Decorative Composition
per: Cravino, Ana María
Publicat: (2020)

High quality of mortar with marble waste aggregate
per: Barbosa, Maria Teresa Gomes, et al.
Publicat: (2018)

Mortar with refractory waste for passive fire protection
per: Lima, Paulo Henrique Pereira, et al.
Publicat: (2020)

Binders, mortars and plasters appropriate to protect the environment.
per: Cedeño Valdiviezo, Alberto
Publicat: (2011)

Environmental and economic perspectives of concrete with high mineral addition content: a case study
per: Isaia, Geraldo Cechella, et al.
Publicat: (2008)

A propos des relations entre nature et ville . Bilan des dialogues franco-lusophones de Tours: es questionnements pour des recherches futures
per: Carrière, Jean-Paul
Publicat: (2020)

The Use of Family Composition and Developed Surface Patterns for an Effective Allocation of Social Housing
per: Vallejos Arcos, Jorge
Publicat: (2000)

Influence of the addition of “synthetic termite saliva” in the compressive strength and water absorption of compacted soil-cement
per: Faria, Obede Borges, et al.
Publicat: (2016)

Comparative study of the chemical additives Consolid 444 and Con-Aid for the improvement of the subgrade in clay soils
per: Guevara Camus, Junior Jeampier, et al.
Publicat: (2023)

Large-Scale Design. Prospects for the Use of Computer-Aided Large-Scale and Fractal Compositions
per: García Alvarado, Rodrigo
Publicat: (1994)

Using ready-mixed mortars in concrete block structural masonry
per: Matos, Paulo Ricardo de, et al.
Publicat: (2020)

Evaluation of early age cracking in rendering mortars with polypropylene fibers
per: Monte, Renata, et al.
Publicat: (2018)

Influence of testing parameters on the determination of the bond strength of mortar renderings
per: Costa, Eliane Betânia Carvalho, et al.
Publicat: (2009)