Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires

Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires

This study compares the performance of two plastering mortars. The first one was produced at a 1:6 proportion of quicklime powder and sand (by volume) and ripened. The second had the same proportion but underwent a water withdrawal process in the oven. The mortars were given the same content of ceme...

Fuld beskrivelse

Saved in:

Bibliografiske detaljer
Main Authors:	Canova, José Aparecido, Bergamasco, Rosangela, Angelis Neto, Generoso de, Gleize, Philippe Jean Paul
Format:	Online
Sprog:	por
Udgivet:	ANTAC - Associação Nacional de Tecnologia do Ambiente Construído 2012
Online adgang:	https://seer.ufrgs.br/ambienteconstruido/article/view/20515
Tags:	Tilføj Tag Ingen Tags, Vær først til at tagge denne postø!

Lignende værker

Structural behavior evaluation of precast slabs prototypes made with tire rubber residue concrete
af: Trigo, Ana Paula Moreno, et al.
Udgivet: (2008)

Evaluation of rheological properties of mortar with TiO2 addition
af: Dantas, Sérgio Roberto Andrade, et al.
Udgivet: (2021)

Shrinkage and the development of mechanical properties in rendering mortars
af: Bastos, Pedro Kopschitz Xavier, et al.
Udgivet: (2008)

Sustainability of the housing of the amazon rubber tapper
af: Lima, Valdeci Candido de
Udgivet: (2010)

Propriedades nanomecânicas do silicato de cálcio hidratado de síntese
af: Pelisser, Fernando, et al.
Udgivet: (2009)

Analysing the logistics impact on the cost composition of a mechanised spraying process of rendering mortar
af: Brandstetter, Maria Carolina Gomes de Oliveira, et al.
Udgivet: (2018)

Correlation between modulus of elasticity dynamic and mechanical strengths of cement mortars and sand with lime addition
af: Silva, Narciso Gonçalves da, et al.
Udgivet: (2008)

The effectiveness of TiO2 additions to mortar to maintain initial conditions in terms of its reflectance to solar radiation
af: Dantas, Sérgio Roberto Andrade, et al.
Udgivet: (2017)

Mechanical properties: wood lumber versus plastic lumber and thermoplastic composites
af: Dias, Bernardo Zandomenico, et al.
Udgivet: (2017)

Impact of the mixer and time of mixing on the properties of industrialized mortar
af: Romano, Roberto Cesar de Oliveira, et al.
Udgivet: (2009)

Mechanical physical study of concrete substitutes with silica powder exposed in simulated aggressive environment
af: Giménez, Alejandro, et al.
Udgivet: (2018)

Rheological characterization of cement paste: association of complementary techniques
af: Betioli, Andrea Murillo, et al.
Udgivet: (2009)

Incorporação de lodo calcinado de estação de tratamento de água como material cimentício suplementar
af: Ruviaro, Artur Spat, et al.
Udgivet: (2020)

Influence of cement type and water content on the fresh state properties of ready mix mortar
af: Casali, Juliana Machado, et al.
Udgivet: (2018)

Influence of polypropylene microfibre (PPMF) dispersion procedure on fresh and hardened rendering mortar properties
af: Dantas, Sérgio Roberto Andrade, et al.
Udgivet: (2020)

Learning, composition and placement in the architecture project.
af: Pérgolis, Juan Carlos, et al.
Udgivet: (2016)

Índice de Serviço das Calçadas (ISC)
af: Silva, Otavio Henrique da, et al.
Udgivet: (2018)

Use of natural additives in construction materials – a review
af: Hernández, Eddisson
Udgivet: (2019)

Composite slim floor: elements and construction process
af: Kochem, Raimundo Fagner Freitas, et al.
Udgivet: (2018)

Crossed perspectives around the doctorate in architecture.
af: Garric, Jean-Philippe
Udgivet: (2015)

BIM and LCA integration proposal using service compositions
af: Silva, Bruno Thiago Rego Valeriano, et al.
Udgivet: (2021)

Drying parameters of rendering mortars
af: Salomão, Maria Cláudia de Freitas, et al.
Udgivet: (2018)

Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars
af: Silva Neto, Gilberto Alves da, et al.
Udgivet: (2018)

Use of adherent additives in designing asphalt hot mixtures: a review
af: Vasquez Llamo, Reinerio Elden, et al.
Udgivet: (2021)

Digital detailing on the edge: joining of complex curved composite panels
af: Chaszar, Andre
Udgivet: (2013)

The Guillermo Bermúdez Umaña’s composition at the Carabelas Building (1969-1972)
af: Güiza-Chaves, Juan Pablo
Udgivet: (2021)

Kaufmann desert house. The landscape through the analysis of the architectural composition
af: Rojas Quiñones, Plutarco
Udgivet: (2021)

Paradoxical Effects of a Forgotten Subject: Life and Death of Decorative Composition
af: Cravino, Ana María
Udgivet: (2020)

High quality of mortar with marble waste aggregate
af: Barbosa, Maria Teresa Gomes, et al.
Udgivet: (2018)

Mortar with refractory waste for passive fire protection
af: Lima, Paulo Henrique Pereira, et al.
Udgivet: (2020)

Binders, mortars and plasters appropriate to protect the environment.
af: Cedeño Valdiviezo, Alberto
Udgivet: (2011)

Environmental and economic perspectives of concrete with high mineral addition content: a case study
af: Isaia, Geraldo Cechella, et al.
Udgivet: (2008)

A propos des relations entre nature et ville . Bilan des dialogues franco-lusophones de Tours: es questionnements pour des recherches futures
af: Carrière, Jean-Paul
Udgivet: (2020)

The Use of Family Composition and Developed Surface Patterns for an Effective Allocation of Social Housing
af: Vallejos Arcos, Jorge
Udgivet: (2000)

Influence of the addition of “synthetic termite saliva” in the compressive strength and water absorption of compacted soil-cement
af: Faria, Obede Borges, et al.
Udgivet: (2016)

Comparative study of the chemical additives Consolid 444 and Con-Aid for the improvement of the subgrade in clay soils
af: Guevara Camus, Junior Jeampier, et al.
Udgivet: (2023)

Large-Scale Design. Prospects for the Use of Computer-Aided Large-Scale and Fractal Compositions
af: García Alvarado, Rodrigo
Udgivet: (1994)

Using ready-mixed mortars in concrete block structural masonry
af: Matos, Paulo Ricardo de, et al.
Udgivet: (2020)

Evaluation of early age cracking in rendering mortars with polypropylene fibers
af: Monte, Renata, et al.
Udgivet: (2018)

Influence of testing parameters on the determination of the bond strength of mortar renderings
af: Costa, Eliane Betânia Carvalho, et al.
Udgivet: (2009)