Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires

Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires

This study compares the performance of two plastering mortars. The first one was produced at a 1:6 proportion of quicklime powder and sand (by volume) and ripened. The second had the same proportion but underwent a water withdrawal process in the oven. The mortars were given the same content of ceme...

पूर्ण विवरण

में बचाया:

ग्रंथसूची विवरण
मुख्य लेखकों:	Canova, José Aparecido, Bergamasco, Rosangela, Angelis Neto, Generoso de, Gleize, Philippe Jean Paul
स्वरूप:	Online
भाषा:	por
प्रकाशित:	ANTAC - Associação Nacional de Tecnologia do Ambiente Construído 2012
ऑनलाइन पहुंच:	https://seer.ufrgs.br/ambienteconstruido/article/view/20515
टैग :	टैग जोड़ें कोई टैग नहीं, इस रिकॉर्ड को टैग करने वाले पहले व्यक्ति बनें!

समान संसाधन

Structural behavior evaluation of precast slabs prototypes made with tire rubber residue concrete
द्वारा: Trigo, Ana Paula Moreno, और अन्य
प्रकाशित: (2008)

Evaluation of rheological properties of mortar with TiO2 addition
द्वारा: Dantas, Sérgio Roberto Andrade, और अन्य
प्रकाशित: (2021)

Shrinkage and the development of mechanical properties in rendering mortars
द्वारा: Bastos, Pedro Kopschitz Xavier, और अन्य
प्रकाशित: (2008)

Sustainability of the housing of the amazon rubber tapper
द्वारा: Lima, Valdeci Candido de
प्रकाशित: (2010)

Propriedades nanomecânicas do silicato de cálcio hidratado de síntese
द्वारा: Pelisser, Fernando, और अन्य
प्रकाशित: (2009)

Analysing the logistics impact on the cost composition of a mechanised spraying process of rendering mortar
द्वारा: Brandstetter, Maria Carolina Gomes de Oliveira, और अन्य
प्रकाशित: (2018)

Correlation between modulus of elasticity dynamic and mechanical strengths of cement mortars and sand with lime addition
द्वारा: Silva, Narciso Gonçalves da, और अन्य
प्रकाशित: (2008)

The effectiveness of TiO2 additions to mortar to maintain initial conditions in terms of its reflectance to solar radiation
द्वारा: Dantas, Sérgio Roberto Andrade, और अन्य
प्रकाशित: (2017)

Mechanical properties: wood lumber versus plastic lumber and thermoplastic composites
द्वारा: Dias, Bernardo Zandomenico, और अन्य
प्रकाशित: (2017)

Impact of the mixer and time of mixing on the properties of industrialized mortar
द्वारा: Romano, Roberto Cesar de Oliveira, और अन्य
प्रकाशित: (2009)

Mechanical physical study of concrete substitutes with silica powder exposed in simulated aggressive environment
द्वारा: Giménez, Alejandro, और अन्य
प्रकाशित: (2018)

Rheological characterization of cement paste: association of complementary techniques
द्वारा: Betioli, Andrea Murillo, और अन्य
प्रकाशित: (2009)

Incorporação de lodo calcinado de estação de tratamento de água como material cimentício suplementar
द्वारा: Ruviaro, Artur Spat, और अन्य
प्रकाशित: (2020)

Influence of cement type and water content on the fresh state properties of ready mix mortar
द्वारा: Casali, Juliana Machado, और अन्य
प्रकाशित: (2018)

Influence of polypropylene microfibre (PPMF) dispersion procedure on fresh and hardened rendering mortar properties
द्वारा: Dantas, Sérgio Roberto Andrade, और अन्य
प्रकाशित: (2020)

Learning, composition and placement in the architecture project.
द्वारा: Pérgolis, Juan Carlos, और अन्य
प्रकाशित: (2016)

Índice de Serviço das Calçadas (ISC)
द्वारा: Silva, Otavio Henrique da, और अन्य
प्रकाशित: (2018)

Use of natural additives in construction materials – a review
द्वारा: Hernández, Eddisson
प्रकाशित: (2019)

Composite slim floor: elements and construction process
द्वारा: Kochem, Raimundo Fagner Freitas, और अन्य
प्रकाशित: (2018)

Crossed perspectives around the doctorate in architecture.
द्वारा: Garric, Jean-Philippe
प्रकाशित: (2015)

BIM and LCA integration proposal using service compositions
द्वारा: Silva, Bruno Thiago Rego Valeriano, और अन्य
प्रकाशित: (2021)

Drying parameters of rendering mortars
द्वारा: Salomão, Maria Cláudia de Freitas, और अन्य
प्रकाशित: (2018)

Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars
द्वारा: Silva Neto, Gilberto Alves da, और अन्य
प्रकाशित: (2018)

Use of adherent additives in designing asphalt hot mixtures: a review
द्वारा: Vasquez Llamo, Reinerio Elden, और अन्य
प्रकाशित: (2021)

Digital detailing on the edge: joining of complex curved composite panels
द्वारा: Chaszar, Andre
प्रकाशित: (2013)

The Guillermo Bermúdez Umaña’s composition at the Carabelas Building (1969-1972)
द्वारा: Güiza-Chaves, Juan Pablo
प्रकाशित: (2021)

Kaufmann desert house. The landscape through the analysis of the architectural composition
द्वारा: Rojas Quiñones, Plutarco
प्रकाशित: (2021)

Paradoxical Effects of a Forgotten Subject: Life and Death of Decorative Composition
द्वारा: Cravino, Ana María
प्रकाशित: (2020)

High quality of mortar with marble waste aggregate
द्वारा: Barbosa, Maria Teresa Gomes, और अन्य
प्रकाशित: (2018)

Mortar with refractory waste for passive fire protection
द्वारा: Lima, Paulo Henrique Pereira, और अन्य
प्रकाशित: (2020)

Binders, mortars and plasters appropriate to protect the environment.
द्वारा: Cedeño Valdiviezo, Alberto
प्रकाशित: (2011)

Environmental and economic perspectives of concrete with high mineral addition content: a case study
द्वारा: Isaia, Geraldo Cechella, और अन्य
प्रकाशित: (2008)

A propos des relations entre nature et ville . Bilan des dialogues franco-lusophones de Tours: es questionnements pour des recherches futures
द्वारा: Carrière, Jean-Paul
प्रकाशित: (2020)

The Use of Family Composition and Developed Surface Patterns for an Effective Allocation of Social Housing
द्वारा: Vallejos Arcos, Jorge
प्रकाशित: (2000)

Influence of the addition of “synthetic termite saliva” in the compressive strength and water absorption of compacted soil-cement
द्वारा: Faria, Obede Borges, और अन्य
प्रकाशित: (2016)

Comparative study of the chemical additives Consolid 444 and Con-Aid for the improvement of the subgrade in clay soils
द्वारा: Guevara Camus, Junior Jeampier, और अन्य
प्रकाशित: (2023)

Large-Scale Design. Prospects for the Use of Computer-Aided Large-Scale and Fractal Compositions
द्वारा: García Alvarado, Rodrigo
प्रकाशित: (1994)

Using ready-mixed mortars in concrete block structural masonry
द्वारा: Matos, Paulo Ricardo de, और अन्य
प्रकाशित: (2020)

Evaluation of early age cracking in rendering mortars with polypropylene fibers
द्वारा: Monte, Renata, और अन्य
प्रकाशित: (2018)

Influence of testing parameters on the determination of the bond strength of mortar renderings
द्वारा: Costa, Eliane Betânia Carvalho, और अन्य
प्रकाशित: (2009)