Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires

Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires

This study compares the performance of two plastering mortars. The first one was produced at a 1:6 proportion of quicklime powder and sand (by volume) and ripened. The second had the same proportion but underwent a water withdrawal process in the oven. The mortars were given the same content of ceme...

Volledige beschrijving

Bewaard in:

Bibliografische gegevens
Hoofdauteurs:	Canova, José Aparecido, Bergamasco, Rosangela, Angelis Neto, Generoso de, Gleize, Philippe Jean Paul
Formaat:	Online
Taal:	por
Gepubliceerd in:	ANTAC - Associação Nacional de Tecnologia do Ambiente Construído 2012
Online toegang:	https://seer.ufrgs.br/ambienteconstruido/article/view/20515
Tags:	Voeg label toe Geen labels, Wees de eerste die dit record labelt!

Gelijkaardige items

Structural behavior evaluation of precast slabs prototypes made with tire rubber residue concrete
door: Trigo, Ana Paula Moreno, et al.
Gepubliceerd in: (2008)

Evaluation of rheological properties of mortar with TiO2 addition
door: Dantas, Sérgio Roberto Andrade, et al.
Gepubliceerd in: (2021)

Shrinkage and the development of mechanical properties in rendering mortars
door: Bastos, Pedro Kopschitz Xavier, et al.
Gepubliceerd in: (2008)

Sustainability of the housing of the amazon rubber tapper
door: Lima, Valdeci Candido de
Gepubliceerd in: (2010)

Propriedades nanomecânicas do silicato de cálcio hidratado de síntese
door: Pelisser, Fernando, et al.
Gepubliceerd in: (2009)

Analysing the logistics impact on the cost composition of a mechanised spraying process of rendering mortar
door: Brandstetter, Maria Carolina Gomes de Oliveira, et al.
Gepubliceerd in: (2018)

Correlation between modulus of elasticity dynamic and mechanical strengths of cement mortars and sand with lime addition
door: Silva, Narciso Gonçalves da, et al.
Gepubliceerd in: (2008)

The effectiveness of TiO2 additions to mortar to maintain initial conditions in terms of its reflectance to solar radiation
door: Dantas, Sérgio Roberto Andrade, et al.
Gepubliceerd in: (2017)

Mechanical properties: wood lumber versus plastic lumber and thermoplastic composites
door: Dias, Bernardo Zandomenico, et al.
Gepubliceerd in: (2017)

Impact of the mixer and time of mixing on the properties of industrialized mortar
door: Romano, Roberto Cesar de Oliveira, et al.
Gepubliceerd in: (2009)

Mechanical physical study of concrete substitutes with silica powder exposed in simulated aggressive environment
door: Giménez, Alejandro, et al.
Gepubliceerd in: (2018)

Rheological characterization of cement paste: association of complementary techniques
door: Betioli, Andrea Murillo, et al.
Gepubliceerd in: (2009)

Incorporação de lodo calcinado de estação de tratamento de água como material cimentício suplementar
door: Ruviaro, Artur Spat, et al.
Gepubliceerd in: (2020)

Influence of cement type and water content on the fresh state properties of ready mix mortar
door: Casali, Juliana Machado, et al.
Gepubliceerd in: (2018)

Influence of polypropylene microfibre (PPMF) dispersion procedure on fresh and hardened rendering mortar properties
door: Dantas, Sérgio Roberto Andrade, et al.
Gepubliceerd in: (2020)

Learning, composition and placement in the architecture project.
door: Pérgolis, Juan Carlos, et al.
Gepubliceerd in: (2016)

Índice de Serviço das Calçadas (ISC)
door: Silva, Otavio Henrique da, et al.
Gepubliceerd in: (2018)

Use of natural additives in construction materials – a review
door: Hernández, Eddisson
Gepubliceerd in: (2019)

Composite slim floor: elements and construction process
door: Kochem, Raimundo Fagner Freitas, et al.
Gepubliceerd in: (2018)

Crossed perspectives around the doctorate in architecture.
door: Garric, Jean-Philippe
Gepubliceerd in: (2015)

BIM and LCA integration proposal using service compositions
door: Silva, Bruno Thiago Rego Valeriano, et al.
Gepubliceerd in: (2021)

Drying parameters of rendering mortars
door: Salomão, Maria Cláudia de Freitas, et al.
Gepubliceerd in: (2018)

Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars
door: Silva Neto, Gilberto Alves da, et al.
Gepubliceerd in: (2018)

Use of adherent additives in designing asphalt hot mixtures: a review
door: Vasquez Llamo, Reinerio Elden, et al.
Gepubliceerd in: (2021)

Digital detailing on the edge: joining of complex curved composite panels
door: Chaszar, Andre
Gepubliceerd in: (2013)

The Guillermo Bermúdez Umaña’s composition at the Carabelas Building (1969-1972)
door: Güiza-Chaves, Juan Pablo
Gepubliceerd in: (2021)

Kaufmann desert house. The landscape through the analysis of the architectural composition
door: Rojas Quiñones, Plutarco
Gepubliceerd in: (2021)

Paradoxical Effects of a Forgotten Subject: Life and Death of Decorative Composition
door: Cravino, Ana María
Gepubliceerd in: (2020)

High quality of mortar with marble waste aggregate
door: Barbosa, Maria Teresa Gomes, et al.
Gepubliceerd in: (2018)

Mortar with refractory waste for passive fire protection
door: Lima, Paulo Henrique Pereira, et al.
Gepubliceerd in: (2020)

Binders, mortars and plasters appropriate to protect the environment.
door: Cedeño Valdiviezo, Alberto
Gepubliceerd in: (2011)

Environmental and economic perspectives of concrete with high mineral addition content: a case study
door: Isaia, Geraldo Cechella, et al.
Gepubliceerd in: (2008)

A propos des relations entre nature et ville . Bilan des dialogues franco-lusophones de Tours: es questionnements pour des recherches futures
door: Carrière, Jean-Paul
Gepubliceerd in: (2020)

The Use of Family Composition and Developed Surface Patterns for an Effective Allocation of Social Housing
door: Vallejos Arcos, Jorge
Gepubliceerd in: (2000)

Influence of the addition of “synthetic termite saliva” in the compressive strength and water absorption of compacted soil-cement
door: Faria, Obede Borges, et al.
Gepubliceerd in: (2016)

Comparative study of the chemical additives Consolid 444 and Con-Aid for the improvement of the subgrade in clay soils
door: Guevara Camus, Junior Jeampier, et al.
Gepubliceerd in: (2023)

Large-Scale Design. Prospects for the Use of Computer-Aided Large-Scale and Fractal Compositions
door: García Alvarado, Rodrigo
Gepubliceerd in: (1994)

Using ready-mixed mortars in concrete block structural masonry
door: Matos, Paulo Ricardo de, et al.
Gepubliceerd in: (2020)

Evaluation of early age cracking in rendering mortars with polypropylene fibers
door: Monte, Renata, et al.
Gepubliceerd in: (2018)

Influence of testing parameters on the determination of the bond strength of mortar renderings
door: Costa, Eliane Betânia Carvalho, et al.
Gepubliceerd in: (2009)