Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires

Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires

This study compares the performance of two plastering mortars. The first one was produced at a 1:6 proportion of quicklime powder and sand (by volume) and ripened. The second had the same proportion but underwent a water withdrawal process in the oven. The mortars were given the same content of ceme...

Полное описание

Сохранить в:

Библиографические подробности
Главные авторы:	Canova, José Aparecido, Bergamasco, Rosangela, Angelis Neto, Generoso de, Gleize, Philippe Jean Paul
Формат:	Online
Язык:	por
Опубликовано:	ANTAC - Associação Nacional de Tecnologia do Ambiente Construído 2012
Online-ссылка:	https://seer.ufrgs.br/ambienteconstruido/article/view/20515
Метки:	Добавить метку Нет меток, Требуется 1-ая метка записи!

Схожие документы

Structural behavior evaluation of precast slabs prototypes made with tire rubber residue concrete
по: Trigo, Ana Paula Moreno, et al.
Опубликовано: (2008)

Evaluation of rheological properties of mortar with TiO2 addition
по: Dantas, Sérgio Roberto Andrade, et al.
Опубликовано: (2021)

Shrinkage and the development of mechanical properties in rendering mortars
по: Bastos, Pedro Kopschitz Xavier, et al.
Опубликовано: (2008)

Sustainability of the housing of the amazon rubber tapper
по: Lima, Valdeci Candido de
Опубликовано: (2010)

Propriedades nanomecânicas do silicato de cálcio hidratado de síntese
по: Pelisser, Fernando, et al.
Опубликовано: (2009)

Analysing the logistics impact on the cost composition of a mechanised spraying process of rendering mortar
по: Brandstetter, Maria Carolina Gomes de Oliveira, et al.
Опубликовано: (2018)

Correlation between modulus of elasticity dynamic and mechanical strengths of cement mortars and sand with lime addition
по: Silva, Narciso Gonçalves da, et al.
Опубликовано: (2008)

The effectiveness of TiO2 additions to mortar to maintain initial conditions in terms of its reflectance to solar radiation
по: Dantas, Sérgio Roberto Andrade, et al.
Опубликовано: (2017)

Mechanical properties: wood lumber versus plastic lumber and thermoplastic composites
по: Dias, Bernardo Zandomenico, et al.
Опубликовано: (2017)

Impact of the mixer and time of mixing on the properties of industrialized mortar
по: Romano, Roberto Cesar de Oliveira, et al.
Опубликовано: (2009)

Mechanical physical study of concrete substitutes with silica powder exposed in simulated aggressive environment
по: Giménez, Alejandro, et al.
Опубликовано: (2018)

Rheological characterization of cement paste: association of complementary techniques
по: Betioli, Andrea Murillo, et al.
Опубликовано: (2009)

Incorporação de lodo calcinado de estação de tratamento de água como material cimentício suplementar
по: Ruviaro, Artur Spat, et al.
Опубликовано: (2020)

Influence of cement type and water content on the fresh state properties of ready mix mortar
по: Casali, Juliana Machado, et al.
Опубликовано: (2018)

Influence of polypropylene microfibre (PPMF) dispersion procedure on fresh and hardened rendering mortar properties
по: Dantas, Sérgio Roberto Andrade, et al.
Опубликовано: (2020)

Learning, composition and placement in the architecture project.
по: Pérgolis, Juan Carlos, et al.
Опубликовано: (2016)

Índice de Serviço das Calçadas (ISC)
по: Silva, Otavio Henrique da, et al.
Опубликовано: (2018)

Use of natural additives in construction materials – a review
по: Hernández, Eddisson
Опубликовано: (2019)

Composite slim floor: elements and construction process
по: Kochem, Raimundo Fagner Freitas, et al.
Опубликовано: (2018)

Crossed perspectives around the doctorate in architecture.
по: Garric, Jean-Philippe
Опубликовано: (2015)

BIM and LCA integration proposal using service compositions
по: Silva, Bruno Thiago Rego Valeriano, et al.
Опубликовано: (2021)

Drying parameters of rendering mortars
по: Salomão, Maria Cláudia de Freitas, et al.
Опубликовано: (2018)

Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars
по: Silva Neto, Gilberto Alves da, et al.
Опубликовано: (2018)

Use of adherent additives in designing asphalt hot mixtures: a review
по: Vasquez Llamo, Reinerio Elden, et al.
Опубликовано: (2021)

Digital detailing on the edge: joining of complex curved composite panels
по: Chaszar, Andre
Опубликовано: (2013)

The Guillermo Bermúdez Umaña’s composition at the Carabelas Building (1969-1972)
по: Güiza-Chaves, Juan Pablo
Опубликовано: (2021)

Kaufmann desert house. The landscape through the analysis of the architectural composition
по: Rojas Quiñones, Plutarco
Опубликовано: (2021)

Paradoxical Effects of a Forgotten Subject: Life and Death of Decorative Composition
по: Cravino, Ana María
Опубликовано: (2020)

High quality of mortar with marble waste aggregate
по: Barbosa, Maria Teresa Gomes, et al.
Опубликовано: (2018)

Mortar with refractory waste for passive fire protection
по: Lima, Paulo Henrique Pereira, et al.
Опубликовано: (2020)

Binders, mortars and plasters appropriate to protect the environment.
по: Cedeño Valdiviezo, Alberto
Опубликовано: (2011)

Environmental and economic perspectives of concrete with high mineral addition content: a case study
по: Isaia, Geraldo Cechella, et al.
Опубликовано: (2008)

A propos des relations entre nature et ville . Bilan des dialogues franco-lusophones de Tours: es questionnements pour des recherches futures
по: Carrière, Jean-Paul
Опубликовано: (2020)

The Use of Family Composition and Developed Surface Patterns for an Effective Allocation of Social Housing
по: Vallejos Arcos, Jorge
Опубликовано: (2000)

Influence of the addition of “synthetic termite saliva” in the compressive strength and water absorption of compacted soil-cement
по: Faria, Obede Borges, et al.
Опубликовано: (2016)

Comparative study of the chemical additives Consolid 444 and Con-Aid for the improvement of the subgrade in clay soils
по: Guevara Camus, Junior Jeampier, et al.
Опубликовано: (2023)

Large-Scale Design. Prospects for the Use of Computer-Aided Large-Scale and Fractal Compositions
по: García Alvarado, Rodrigo
Опубликовано: (1994)

Using ready-mixed mortars in concrete block structural masonry
по: Matos, Paulo Ricardo de, et al.
Опубликовано: (2020)

Evaluation of early age cracking in rendering mortars with polypropylene fibers
по: Monte, Renata, et al.
Опубликовано: (2018)

Influence of testing parameters on the determination of the bond strength of mortar renderings
по: Costa, Eliane Betânia Carvalho, et al.
Опубликовано: (2009)