Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars

Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars

The objective of this study was to investigate the behavior of mortars by replacing a natural fine aggregate (NFA) with mortar fine recycled aggregate (MFRA), with dimensions of less than 2.4mm. In addition, the influence of the mixing sequence over the performance of these mortars was analyzed. Fo...

Descripció completa

Guardat en:

Dades bibliogràfiques
Autors principals:	Silva Neto, Gilberto Alves da, Leite, Mônica Batista
Format:	Online
Idioma:	eng
Publicat:	ANTAC - Associação Nacional de Tecnologia do Ambiente Construído 2018
Accés en línia:	https://seer.ufrgs.br/ambienteconstruido/article/view/72668
Etiquetes:	Afegir etiqueta Sense etiquetes, Sigues el primer a etiquetar aquest registre!

Ítems similars

High quality of mortar with marble waste aggregate
per: Barbosa, Maria Teresa Gomes, et al.
Publicat: (2018)

Influence of cement type and water content on the fresh state properties of ready mix mortar
per: Casali, Juliana Machado, et al.
Publicat: (2018)

Impact of the mixer and time of mixing on the properties of industrialized mortar
per: Romano, Roberto Cesar de Oliveira, et al.
Publicat: (2009)

Influence of the moisture content on the dynamic modulus of elasticity of concrete made with recycled aggregate
per: Kazmierczak, Claudio de Souza, et al.
Publicat: (2019)

Using ready-mixed mortars in concrete block structural masonry
per: Matos, Paulo Ricardo de, et al.
Publicat: (2020)

Influence of testing parameters on the determination of the bond strength of mortar renderings
per: Costa, Eliane Betânia Carvalho, et al.
Publicat: (2009)

Influence of ceramic block geometry and mortar coating on the sound reduction of walls
per: Oliveira, Maria Fernanda de, et al.
Publicat: (2021)

Influence of polypropylene microfibre (PPMF) dispersion procedure on fresh and hardened rendering mortar properties
per: Dantas, Sérgio Roberto Andrade, et al.
Publicat: (2020)

Drying parameters of rendering mortars
per: Salomão, Maria Cláudia de Freitas, et al.
Publicat: (2018)

Mortar with refractory waste for passive fire protection
per: Lima, Paulo Henrique Pereira, et al.
Publicat: (2020)

The influence of water loss by evaporation in the tensile adhesion strength between dry-set mortar and ceramic tiles
per: Póvoas, Yêda Vieira, et al.
Publicat: (2008)

Shrinkage and the development of mechanical properties in rendering mortars
per: Bastos, Pedro Kopschitz Xavier, et al.
Publicat: (2008)

Binders, mortars and plasters appropriate to protect the environment.
per: Cedeño Valdiviezo, Alberto
Publicat: (2011)

Porosity estimation of cement-lime mortar through the volume calculation method
per: Quarcioni, Valdecir Angelo, et al.
Publicat: (2009)

Comparative analysis of the strength to compression, flexure and workability of traditional concrete versus a concrete using steel slag as fine aggregate
per: Camarena Flores, Armando, et al.
Publicat: (2022)

Evaluation of rheological properties of mortar with TiO2 addition
per: Dantas, Sérgio Roberto Andrade, et al.
Publicat: (2021)

Evaluation of early age cracking in rendering mortars with polypropylene fibers
per: Monte, Renata, et al.
Publicat: (2018)

Structural reinforcement in townhouses by covering masonry with welded mesh and mortar
per: Castillo Robles, Cristhian, et al.
Publicat: (2022)

Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires
per: Canova, José Aparecido, et al.
Publicat: (2012)

Proposal of a method for obtaining an economic dosage for clay-containing mortars
per: Gomes, Adailton de Oliveira, et al.
Publicat: (2008)

Physical-mechanical performance criteria of cement-soil mortars for earth building coating
per: Milani, Ana Paula da Silva, et al.
Publicat: (2018)

Didactic sequences in the threedimensional field with the manual and digital means interaction
per: Cabezas, María
Publicat: (2007)

Analysing the logistics impact on the cost composition of a mechanised spraying process of rendering mortar
per: Brandstetter, Maria Carolina Gomes de Oliveira, et al.
Publicat: (2018)

Method for obtaining the independency between strength and elasticity in proportioning studies of cement and lime mortar
per: Dafico, Dario de Araújo
Publicat: (2008)

Analysis of the stresses in the interface between dry-set mortar and ceramic tiles under thermic efforts
per: Saraiva, Ana Gabriela, et al.
Publicat: (2008)

Correlation between modulus of elasticity dynamic and mechanical strengths of cement mortars and sand with lime addition
per: Silva, Narciso Gonçalves da, et al.
Publicat: (2008)

Mix and Use
per: Chaverri Peralta, Felipe
Publicat: (2016)

Evaluation of the petatillo made with cement-sand mortar as an alternative material for the construction of the prefabricated roof component Domotej
per: González García, Eddy, et al.
Publicat: (2018)

Recycled gypsum block: development and performance
per: Santana, Clóvis Veloso, et al.
Publicat: (2019)

The effectiveness of TiO2 additions to mortar to maintain initial conditions in terms of its reflectance to solar radiation
per: Dantas, Sérgio Roberto Andrade, et al.
Publicat: (2017)

The development of a tool to validate the influence of user behavior on energy efficiency in public office buildings
per: Alonso-Frank, Alción de las Pléyades, et al.
Publicat: (2016)

Seismic behavior of reinforced concrete porticoes under the influence of the strong portion in a soft soil
per: Rodríguez Gómez, Hermenegildo
Publicat: (2014)

Synergistic effect of RHA and FCW in alkali-aggregate reaction mitigation
per: Guillante, Patrícia, et al.
Publicat: (2019)

Recycled plastic bricks and panels for selfconstruction
per: Gaggino, Rosana
Publicat: (2008)

Recycled concrete: chances to research in pre graduate
per: Rivera, Emely, et al.
Publicat: (2020)

Determination the probability distribution of the concrete mixing components
per: Suárez Pereira, Mariana, et al.
Publicat: (2021)

UNTITLED CUTTING: LOOKING FOR MATTA-CLARK AT THE FINE ARTS…
per: Barría Chateau, Hernán Alberto
Publicat: (2017)

MIX-MEDIA NARRATIVES WORKSHOP: MULTIDISCIPLINARY TEAMS’ PRODUCTION
per: Vieira, Sonia Liliana da Silva, et al.
Publicat: (2017)

Integration of PET recycled to flexion in a concreteconstruction element
per: Silva Herrera, Raymundo, et al.
Publicat: (2019)

El Diseño Urbano de fines del siglo XX
per: Fox Timmling, Hans
Publicat: (1987)