Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars

Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars

The objective of this study was to investigate the behavior of mortars by replacing a natural fine aggregate (NFA) with mortar fine recycled aggregate (MFRA), with dimensions of less than 2.4mm. In addition, the influence of the mixing sequence over the performance of these mortars was analyzed. Fo...

Spremljeno u:

Bibliografski detalji
Glavni autori:	Silva Neto, Gilberto Alves da, Leite, Mônica Batista
Format:	Online
Jezik:	eng
Izdano:	ANTAC - Associação Nacional de Tecnologia do Ambiente Construído 2018
Online pristup:	https://seer.ufrgs.br/ambienteconstruido/article/view/72668
Oznake:	Dodaj oznaku Bez oznaka, Budi prvi tko označuje ovaj zapis!

Similar Items

High quality of mortar with marble waste aggregate
od: Barbosa, Maria Teresa Gomes, i dr.
Izdano: (2018)

Influence of cement type and water content on the fresh state properties of ready mix mortar
od: Casali, Juliana Machado, i dr.
Izdano: (2018)

Impact of the mixer and time of mixing on the properties of industrialized mortar
od: Romano, Roberto Cesar de Oliveira, i dr.
Izdano: (2009)

Influence of the moisture content on the dynamic modulus of elasticity of concrete made with recycled aggregate
od: Kazmierczak, Claudio de Souza, i dr.
Izdano: (2019)

Using ready-mixed mortars in concrete block structural masonry
od: Matos, Paulo Ricardo de, i dr.
Izdano: (2020)

Influence of testing parameters on the determination of the bond strength of mortar renderings
od: Costa, Eliane Betânia Carvalho, i dr.
Izdano: (2009)

Influence of ceramic block geometry and mortar coating on the sound reduction of walls
od: Oliveira, Maria Fernanda de, i dr.
Izdano: (2021)

Influence of polypropylene microfibre (PPMF) dispersion procedure on fresh and hardened rendering mortar properties
od: Dantas, Sérgio Roberto Andrade, i dr.
Izdano: (2020)

Drying parameters of rendering mortars
od: Salomão, Maria Cláudia de Freitas, i dr.
Izdano: (2018)

Mortar with refractory waste for passive fire protection
od: Lima, Paulo Henrique Pereira, i dr.
Izdano: (2020)

The influence of water loss by evaporation in the tensile adhesion strength between dry-set mortar and ceramic tiles
od: Póvoas, Yêda Vieira, i dr.
Izdano: (2008)

Shrinkage and the development of mechanical properties in rendering mortars
od: Bastos, Pedro Kopschitz Xavier, i dr.
Izdano: (2008)

Binders, mortars and plasters appropriate to protect the environment.
od: Cedeño Valdiviezo, Alberto
Izdano: (2011)

Porosity estimation of cement-lime mortar through the volume calculation method
od: Quarcioni, Valdecir Angelo, i dr.
Izdano: (2009)

Comparative analysis of the strength to compression, flexure and workability of traditional concrete versus a concrete using steel slag as fine aggregate
od: Camarena Flores, Armando, i dr.
Izdano: (2022)

Evaluation of rheological properties of mortar with TiO2 addition
od: Dantas, Sérgio Roberto Andrade, i dr.
Izdano: (2021)

Evaluation of early age cracking in rendering mortars with polypropylene fibers
od: Monte, Renata, i dr.
Izdano: (2018)

Structural reinforcement in townhouses by covering masonry with welded mesh and mortar
od: Castillo Robles, Cristhian, i dr.
Izdano: (2022)

Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires
od: Canova, José Aparecido, i dr.
Izdano: (2012)

Proposal of a method for obtaining an economic dosage for clay-containing mortars
od: Gomes, Adailton de Oliveira, i dr.
Izdano: (2008)

Physical-mechanical performance criteria of cement-soil mortars for earth building coating
od: Milani, Ana Paula da Silva, i dr.
Izdano: (2018)

Didactic sequences in the threedimensional field with the manual and digital means interaction
od: Cabezas, María
Izdano: (2007)

Analysing the logistics impact on the cost composition of a mechanised spraying process of rendering mortar
od: Brandstetter, Maria Carolina Gomes de Oliveira, i dr.
Izdano: (2018)

Method for obtaining the independency between strength and elasticity in proportioning studies of cement and lime mortar
od: Dafico, Dario de Araújo
Izdano: (2008)

Analysis of the stresses in the interface between dry-set mortar and ceramic tiles under thermic efforts
od: Saraiva, Ana Gabriela, i dr.
Izdano: (2008)

Correlation between modulus of elasticity dynamic and mechanical strengths of cement mortars and sand with lime addition
od: Silva, Narciso Gonçalves da, i dr.
Izdano: (2008)

Mix and Use
od: Chaverri Peralta, Felipe
Izdano: (2016)

Evaluation of the petatillo made with cement-sand mortar as an alternative material for the construction of the prefabricated roof component Domotej
od: González García, Eddy, i dr.
Izdano: (2018)

Recycled gypsum block: development and performance
od: Santana, Clóvis Veloso, i dr.
Izdano: (2019)

The effectiveness of TiO2 additions to mortar to maintain initial conditions in terms of its reflectance to solar radiation
od: Dantas, Sérgio Roberto Andrade, i dr.
Izdano: (2017)

The development of a tool to validate the influence of user behavior on energy efficiency in public office buildings
od: Alonso-Frank, Alción de las Pléyades, i dr.
Izdano: (2016)

Seismic behavior of reinforced concrete porticoes under the influence of the strong portion in a soft soil
od: Rodríguez Gómez, Hermenegildo
Izdano: (2014)

Synergistic effect of RHA and FCW in alkali-aggregate reaction mitigation
od: Guillante, Patrícia, i dr.
Izdano: (2019)

Recycled plastic bricks and panels for selfconstruction
od: Gaggino, Rosana
Izdano: (2008)

Recycled concrete: chances to research in pre graduate
od: Rivera, Emely, i dr.
Izdano: (2020)

Determination the probability distribution of the concrete mixing components
od: Suárez Pereira, Mariana, i dr.
Izdano: (2021)

UNTITLED CUTTING: LOOKING FOR MATTA-CLARK AT THE FINE ARTS…
od: Barría Chateau, Hernán Alberto
Izdano: (2017)

MIX-MEDIA NARRATIVES WORKSHOP: MULTIDISCIPLINARY TEAMS’ PRODUCTION
od: Vieira, Sonia Liliana da Silva, i dr.
Izdano: (2017)

Integration of PET recycled to flexion in a concreteconstruction element
od: Silva Herrera, Raymundo, i dr.
Izdano: (2019)

El Diseño Urbano de fines del siglo XX
od: Fox Timmling, Hans
Izdano: (1987)