Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars

Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars

The objective of this study was to investigate the behavior of mortars by replacing a natural fine aggregate (NFA) with mortar fine recycled aggregate (MFRA), with dimensions of less than 2.4mm. In addition, the influence of the mixing sequence over the performance of these mortars was analyzed. Fo...

Descrizione completa

Salvato in:

Dettagli Bibliografici
Autori principali:	Silva Neto, Gilberto Alves da, Leite, Mônica Batista
Natura:	Online
Lingua:	eng
Pubblicazione:	ANTAC - Associação Nacional de Tecnologia do Ambiente Construído 2018
Accesso online:	https://seer.ufrgs.br/ambienteconstruido/article/view/72668
Tags:	Aggiungi Tag Nessun Tag, puoi essere il primo ad aggiungerne! !

Documenti analoghi

High quality of mortar with marble waste aggregate
di: Barbosa, Maria Teresa Gomes, et al.
Pubblicazione: (2018)

Influence of cement type and water content on the fresh state properties of ready mix mortar
di: Casali, Juliana Machado, et al.
Pubblicazione: (2018)

Impact of the mixer and time of mixing on the properties of industrialized mortar
di: Romano, Roberto Cesar de Oliveira, et al.
Pubblicazione: (2009)

Influence of the moisture content on the dynamic modulus of elasticity of concrete made with recycled aggregate
di: Kazmierczak, Claudio de Souza, et al.
Pubblicazione: (2019)

Using ready-mixed mortars in concrete block structural masonry
di: Matos, Paulo Ricardo de, et al.
Pubblicazione: (2020)

Influence of testing parameters on the determination of the bond strength of mortar renderings
di: Costa, Eliane Betânia Carvalho, et al.
Pubblicazione: (2009)

Influence of ceramic block geometry and mortar coating on the sound reduction of walls
di: Oliveira, Maria Fernanda de, et al.
Pubblicazione: (2021)

Influence of polypropylene microfibre (PPMF) dispersion procedure on fresh and hardened rendering mortar properties
di: Dantas, Sérgio Roberto Andrade, et al.
Pubblicazione: (2020)

Drying parameters of rendering mortars
di: Salomão, Maria Cláudia de Freitas, et al.
Pubblicazione: (2018)

Mortar with refractory waste for passive fire protection
di: Lima, Paulo Henrique Pereira, et al.
Pubblicazione: (2020)

The influence of water loss by evaporation in the tensile adhesion strength between dry-set mortar and ceramic tiles
di: Póvoas, Yêda Vieira, et al.
Pubblicazione: (2008)

Shrinkage and the development of mechanical properties in rendering mortars
di: Bastos, Pedro Kopschitz Xavier, et al.
Pubblicazione: (2008)

Binders, mortars and plasters appropriate to protect the environment.
di: Cedeño Valdiviezo, Alberto
Pubblicazione: (2011)

Porosity estimation of cement-lime mortar through the volume calculation method
di: Quarcioni, Valdecir Angelo, et al.
Pubblicazione: (2009)

Comparative analysis of the strength to compression, flexure and workability of traditional concrete versus a concrete using steel slag as fine aggregate
di: Camarena Flores, Armando, et al.
Pubblicazione: (2022)

Evaluation of rheological properties of mortar with TiO2 addition
di: Dantas, Sérgio Roberto Andrade, et al.
Pubblicazione: (2021)

Evaluation of early age cracking in rendering mortars with polypropylene fibers
di: Monte, Renata, et al.
Pubblicazione: (2018)

Structural reinforcement in townhouses by covering masonry with welded mesh and mortar
di: Castillo Robles, Cristhian, et al.
Pubblicazione: (2022)

Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires
di: Canova, José Aparecido, et al.
Pubblicazione: (2012)

Proposal of a method for obtaining an economic dosage for clay-containing mortars
di: Gomes, Adailton de Oliveira, et al.
Pubblicazione: (2008)

Physical-mechanical performance criteria of cement-soil mortars for earth building coating
di: Milani, Ana Paula da Silva, et al.
Pubblicazione: (2018)

Didactic sequences in the threedimensional field with the manual and digital means interaction
di: Cabezas, María
Pubblicazione: (2007)

Analysing the logistics impact on the cost composition of a mechanised spraying process of rendering mortar
di: Brandstetter, Maria Carolina Gomes de Oliveira, et al.
Pubblicazione: (2018)

Method for obtaining the independency between strength and elasticity in proportioning studies of cement and lime mortar
di: Dafico, Dario de Araújo
Pubblicazione: (2008)

Analysis of the stresses in the interface between dry-set mortar and ceramic tiles under thermic efforts
di: Saraiva, Ana Gabriela, et al.
Pubblicazione: (2008)

Correlation between modulus of elasticity dynamic and mechanical strengths of cement mortars and sand with lime addition
di: Silva, Narciso Gonçalves da, et al.
Pubblicazione: (2008)

Mix and Use
di: Chaverri Peralta, Felipe
Pubblicazione: (2016)

Evaluation of the petatillo made with cement-sand mortar as an alternative material for the construction of the prefabricated roof component Domotej
di: González García, Eddy, et al.
Pubblicazione: (2018)

Recycled gypsum block: development and performance
di: Santana, Clóvis Veloso, et al.
Pubblicazione: (2019)

The effectiveness of TiO2 additions to mortar to maintain initial conditions in terms of its reflectance to solar radiation
di: Dantas, Sérgio Roberto Andrade, et al.
Pubblicazione: (2017)

The development of a tool to validate the influence of user behavior on energy efficiency in public office buildings
di: Alonso-Frank, Alción de las Pléyades, et al.
Pubblicazione: (2016)

Seismic behavior of reinforced concrete porticoes under the influence of the strong portion in a soft soil
di: Rodríguez Gómez, Hermenegildo
Pubblicazione: (2014)

Synergistic effect of RHA and FCW in alkali-aggregate reaction mitigation
di: Guillante, Patrícia, et al.
Pubblicazione: (2019)

Recycled plastic bricks and panels for selfconstruction
di: Gaggino, Rosana
Pubblicazione: (2008)

Recycled concrete: chances to research in pre graduate
di: Rivera, Emely, et al.
Pubblicazione: (2020)

Determination the probability distribution of the concrete mixing components
di: Suárez Pereira, Mariana, et al.
Pubblicazione: (2021)

UNTITLED CUTTING: LOOKING FOR MATTA-CLARK AT THE FINE ARTS…
di: Barría Chateau, Hernán Alberto
Pubblicazione: (2017)

MIX-MEDIA NARRATIVES WORKSHOP: MULTIDISCIPLINARY TEAMS’ PRODUCTION
di: Vieira, Sonia Liliana da Silva, et al.
Pubblicazione: (2017)

Integration of PET recycled to flexion in a concreteconstruction element
di: Silva Herrera, Raymundo, et al.
Pubblicazione: (2019)

El Diseño Urbano de fines del siglo XX
di: Fox Timmling, Hans
Pubblicazione: (1987)