Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars

Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars

The objective of this study was to investigate the behavior of mortars by replacing a natural fine aggregate (NFA) with mortar fine recycled aggregate (MFRA), with dimensions of less than 2.4mm. In addition, the influence of the mixing sequence over the performance of these mortars was analyzed. Fo...

Volledige beschrijving

Bewaard in:

Bibliografische gegevens
Hoofdauteurs:	Silva Neto, Gilberto Alves da, Leite, Mônica Batista
Formaat:	Online
Taal:	eng
Gepubliceerd in:	ANTAC - Associação Nacional de Tecnologia do Ambiente Construído 2018
Online toegang:	https://seer.ufrgs.br/ambienteconstruido/article/view/72668
Tags:	Voeg label toe Geen labels, Wees de eerste die dit record labelt!

Gelijkaardige items

High quality of mortar with marble waste aggregate
door: Barbosa, Maria Teresa Gomes, et al.
Gepubliceerd in: (2018)

Influence of cement type and water content on the fresh state properties of ready mix mortar
door: Casali, Juliana Machado, et al.
Gepubliceerd in: (2018)

Impact of the mixer and time of mixing on the properties of industrialized mortar
door: Romano, Roberto Cesar de Oliveira, et al.
Gepubliceerd in: (2009)

Influence of the moisture content on the dynamic modulus of elasticity of concrete made with recycled aggregate
door: Kazmierczak, Claudio de Souza, et al.
Gepubliceerd in: (2019)

Using ready-mixed mortars in concrete block structural masonry
door: Matos, Paulo Ricardo de, et al.
Gepubliceerd in: (2020)

Influence of testing parameters on the determination of the bond strength of mortar renderings
door: Costa, Eliane Betânia Carvalho, et al.
Gepubliceerd in: (2009)

Influence of ceramic block geometry and mortar coating on the sound reduction of walls
door: Oliveira, Maria Fernanda de, et al.
Gepubliceerd in: (2021)

Influence of polypropylene microfibre (PPMF) dispersion procedure on fresh and hardened rendering mortar properties
door: Dantas, Sérgio Roberto Andrade, et al.
Gepubliceerd in: (2020)

Drying parameters of rendering mortars
door: Salomão, Maria Cláudia de Freitas, et al.
Gepubliceerd in: (2018)

Mortar with refractory waste for passive fire protection
door: Lima, Paulo Henrique Pereira, et al.
Gepubliceerd in: (2020)

The influence of water loss by evaporation in the tensile adhesion strength between dry-set mortar and ceramic tiles
door: Póvoas, Yêda Vieira, et al.
Gepubliceerd in: (2008)

Shrinkage and the development of mechanical properties in rendering mortars
door: Bastos, Pedro Kopschitz Xavier, et al.
Gepubliceerd in: (2008)

Binders, mortars and plasters appropriate to protect the environment.
door: Cedeño Valdiviezo, Alberto
Gepubliceerd in: (2011)

Porosity estimation of cement-lime mortar through the volume calculation method
door: Quarcioni, Valdecir Angelo, et al.
Gepubliceerd in: (2009)

Comparative analysis of the strength to compression, flexure and workability of traditional concrete versus a concrete using steel slag as fine aggregate
door: Camarena Flores, Armando, et al.
Gepubliceerd in: (2022)

Evaluation of rheological properties of mortar with TiO2 addition
door: Dantas, Sérgio Roberto Andrade, et al.
Gepubliceerd in: (2021)

Evaluation of early age cracking in rendering mortars with polypropylene fibers
door: Monte, Renata, et al.
Gepubliceerd in: (2018)

Structural reinforcement in townhouses by covering masonry with welded mesh and mortar
door: Castillo Robles, Cristhian, et al.
Gepubliceerd in: (2022)

Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires
door: Canova, José Aparecido, et al.
Gepubliceerd in: (2012)

Proposal of a method for obtaining an economic dosage for clay-containing mortars
door: Gomes, Adailton de Oliveira, et al.
Gepubliceerd in: (2008)

Physical-mechanical performance criteria of cement-soil mortars for earth building coating
door: Milani, Ana Paula da Silva, et al.
Gepubliceerd in: (2018)

Didactic sequences in the threedimensional field with the manual and digital means interaction
door: Cabezas, María
Gepubliceerd in: (2007)

Analysing the logistics impact on the cost composition of a mechanised spraying process of rendering mortar
door: Brandstetter, Maria Carolina Gomes de Oliveira, et al.
Gepubliceerd in: (2018)

Method for obtaining the independency between strength and elasticity in proportioning studies of cement and lime mortar
door: Dafico, Dario de Araújo
Gepubliceerd in: (2008)

Analysis of the stresses in the interface between dry-set mortar and ceramic tiles under thermic efforts
door: Saraiva, Ana Gabriela, et al.
Gepubliceerd in: (2008)

Correlation between modulus of elasticity dynamic and mechanical strengths of cement mortars and sand with lime addition
door: Silva, Narciso Gonçalves da, et al.
Gepubliceerd in: (2008)

Mix and Use
door: Chaverri Peralta, Felipe
Gepubliceerd in: (2016)

Evaluation of the petatillo made with cement-sand mortar as an alternative material for the construction of the prefabricated roof component Domotej
door: González García, Eddy, et al.
Gepubliceerd in: (2018)

Recycled gypsum block: development and performance
door: Santana, Clóvis Veloso, et al.
Gepubliceerd in: (2019)

The effectiveness of TiO2 additions to mortar to maintain initial conditions in terms of its reflectance to solar radiation
door: Dantas, Sérgio Roberto Andrade, et al.
Gepubliceerd in: (2017)

The development of a tool to validate the influence of user behavior on energy efficiency in public office buildings
door: Alonso-Frank, Alción de las Pléyades, et al.
Gepubliceerd in: (2016)

Seismic behavior of reinforced concrete porticoes under the influence of the strong portion in a soft soil
door: Rodríguez Gómez, Hermenegildo
Gepubliceerd in: (2014)

Synergistic effect of RHA and FCW in alkali-aggregate reaction mitigation
door: Guillante, Patrícia, et al.
Gepubliceerd in: (2019)

Recycled plastic bricks and panels for selfconstruction
door: Gaggino, Rosana
Gepubliceerd in: (2008)

Recycled concrete: chances to research in pre graduate
door: Rivera, Emely, et al.
Gepubliceerd in: (2020)

Determination the probability distribution of the concrete mixing components
door: Suárez Pereira, Mariana, et al.
Gepubliceerd in: (2021)

UNTITLED CUTTING: LOOKING FOR MATTA-CLARK AT THE FINE ARTS…
door: Barría Chateau, Hernán Alberto
Gepubliceerd in: (2017)

MIX-MEDIA NARRATIVES WORKSHOP: MULTIDISCIPLINARY TEAMS’ PRODUCTION
door: Vieira, Sonia Liliana da Silva, et al.
Gepubliceerd in: (2017)

Integration of PET recycled to flexion in a concreteconstruction element
door: Silva Herrera, Raymundo, et al.
Gepubliceerd in: (2019)

El Diseño Urbano de fines del siglo XX
door: Fox Timmling, Hans
Gepubliceerd in: (1987)