Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars

Study of the influence of the mortar fine recycled aggregate ratio and the mixing sequence on the behavior of new mortars

The objective of this study was to investigate the behavior of mortars by replacing a natural fine aggregate (NFA) with mortar fine recycled aggregate (MFRA), with dimensions of less than 2.4mm. In addition, the influence of the mixing sequence over the performance of these mortars was analyzed. Fo...

Полное описание

Сохранить в:

Библиографические подробности
Главные авторы:	Silva Neto, Gilberto Alves da, Leite, Mônica Batista
Формат:	Online
Язык:	eng
Опубликовано:	ANTAC - Associação Nacional de Tecnologia do Ambiente Construído 2018
Online-ссылка:	https://seer.ufrgs.br/ambienteconstruido/article/view/72668
Метки:	Добавить метку Нет меток, Требуется 1-ая метка записи!

Схожие документы

High quality of mortar with marble waste aggregate
по: Barbosa, Maria Teresa Gomes, et al.
Опубликовано: (2018)

Influence of cement type and water content on the fresh state properties of ready mix mortar
по: Casali, Juliana Machado, et al.
Опубликовано: (2018)

Impact of the mixer and time of mixing on the properties of industrialized mortar
по: Romano, Roberto Cesar de Oliveira, et al.
Опубликовано: (2009)

Influence of the moisture content on the dynamic modulus of elasticity of concrete made with recycled aggregate
по: Kazmierczak, Claudio de Souza, et al.
Опубликовано: (2019)

Using ready-mixed mortars in concrete block structural masonry
по: Matos, Paulo Ricardo de, et al.
Опубликовано: (2020)

Influence of testing parameters on the determination of the bond strength of mortar renderings
по: Costa, Eliane Betânia Carvalho, et al.
Опубликовано: (2009)

Influence of ceramic block geometry and mortar coating on the sound reduction of walls
по: Oliveira, Maria Fernanda de, et al.
Опубликовано: (2021)

Influence of polypropylene microfibre (PPMF) dispersion procedure on fresh and hardened rendering mortar properties
по: Dantas, Sérgio Roberto Andrade, et al.
Опубликовано: (2020)

Drying parameters of rendering mortars
по: Salomão, Maria Cláudia de Freitas, et al.
Опубликовано: (2018)

Mortar with refractory waste for passive fire protection
по: Lima, Paulo Henrique Pereira, et al.
Опубликовано: (2020)

The influence of water loss by evaporation in the tensile adhesion strength between dry-set mortar and ceramic tiles
по: Póvoas, Yêda Vieira, et al.
Опубликовано: (2008)

Shrinkage and the development of mechanical properties in rendering mortars
по: Bastos, Pedro Kopschitz Xavier, et al.
Опубликовано: (2008)

Binders, mortars and plasters appropriate to protect the environment.
по: Cedeño Valdiviezo, Alberto
Опубликовано: (2011)

Porosity estimation of cement-lime mortar through the volume calculation method
по: Quarcioni, Valdecir Angelo, et al.
Опубликовано: (2009)

Comparative analysis of the strength to compression, flexure and workability of traditional concrete versus a concrete using steel slag as fine aggregate
по: Camarena Flores, Armando, et al.
Опубликовано: (2022)

Evaluation of rheological properties of mortar with TiO2 addition
по: Dantas, Sérgio Roberto Andrade, et al.
Опубликовано: (2021)

Evaluation of early age cracking in rendering mortars with polypropylene fibers
по: Monte, Renata, et al.
Опубликовано: (2018)

Structural reinforcement in townhouses by covering masonry with welded mesh and mortar
по: Castillo Robles, Cristhian, et al.
Опубликовано: (2022)

Comparative analysis of the properties of composite mortar with addition of rubber powder from worn tires
по: Canova, José Aparecido, et al.
Опубликовано: (2012)

Proposal of a method for obtaining an economic dosage for clay-containing mortars
по: Gomes, Adailton de Oliveira, et al.
Опубликовано: (2008)

Physical-mechanical performance criteria of cement-soil mortars for earth building coating
по: Milani, Ana Paula da Silva, et al.
Опубликовано: (2018)

Didactic sequences in the threedimensional field with the manual and digital means interaction
по: Cabezas, María
Опубликовано: (2007)

Analysing the logistics impact on the cost composition of a mechanised spraying process of rendering mortar
по: Brandstetter, Maria Carolina Gomes de Oliveira, et al.
Опубликовано: (2018)

Method for obtaining the independency between strength and elasticity in proportioning studies of cement and lime mortar
по: Dafico, Dario de Araújo
Опубликовано: (2008)

Analysis of the stresses in the interface between dry-set mortar and ceramic tiles under thermic efforts
по: Saraiva, Ana Gabriela, et al.
Опубликовано: (2008)

Correlation between modulus of elasticity dynamic and mechanical strengths of cement mortars and sand with lime addition
по: Silva, Narciso Gonçalves da, et al.
Опубликовано: (2008)

Mix and Use
по: Chaverri Peralta, Felipe
Опубликовано: (2016)

Evaluation of the petatillo made with cement-sand mortar as an alternative material for the construction of the prefabricated roof component Domotej
по: González García, Eddy, et al.
Опубликовано: (2018)

Recycled gypsum block: development and performance
по: Santana, Clóvis Veloso, et al.
Опубликовано: (2019)

The effectiveness of TiO2 additions to mortar to maintain initial conditions in terms of its reflectance to solar radiation
по: Dantas, Sérgio Roberto Andrade, et al.
Опубликовано: (2017)

The development of a tool to validate the influence of user behavior on energy efficiency in public office buildings
по: Alonso-Frank, Alción de las Pléyades, et al.
Опубликовано: (2016)

Seismic behavior of reinforced concrete porticoes under the influence of the strong portion in a soft soil
по: Rodríguez Gómez, Hermenegildo
Опубликовано: (2014)

Synergistic effect of RHA and FCW in alkali-aggregate reaction mitigation
по: Guillante, Patrícia, et al.
Опубликовано: (2019)

Recycled plastic bricks and panels for selfconstruction
по: Gaggino, Rosana
Опубликовано: (2008)

Recycled concrete: chances to research in pre graduate
по: Rivera, Emely, et al.
Опубликовано: (2020)

Determination the probability distribution of the concrete mixing components
по: Suárez Pereira, Mariana, et al.
Опубликовано: (2021)

UNTITLED CUTTING: LOOKING FOR MATTA-CLARK AT THE FINE ARTS…
по: Barría Chateau, Hernán Alberto
Опубликовано: (2017)

MIX-MEDIA NARRATIVES WORKSHOP: MULTIDISCIPLINARY TEAMS’ PRODUCTION
по: Vieira, Sonia Liliana da Silva, et al.
Опубликовано: (2017)

Integration of PET recycled to flexion in a concreteconstruction element
по: Silva Herrera, Raymundo, et al.
Опубликовано: (2019)

El Diseño Urbano de fines del siglo XX
по: Fox Timmling, Hans
Опубликовано: (1987)